The yellow background is the warning, that the load of the interfaces has not been done so far. Edit -> Preferences -> Captureĭisable interface load at wireshark startupĪfter that Wireshark will skip the load of interfaces at the startup phase. You can select “Don´t load interfaces on startup” in the preferences at the following section. Enter udp in the Capture Filter bar and press Enter to start. It’s the one directly above your network list. As I start Wireshark in most cases directly, this tip does not work often for me.ĭisable the interface discovery at startupĪnother way is, that you can disable the load of interfaces at the startup process of Wireshark. Look for the Capture Filter bar on the welcome screen. double click a pcapng file) then wireshark, will skip loading the interfaces, too. If you open Wireshark indirectly via opening a file (e.g.

Opening Wireshark by double clicking a supported file format Advertisement Step-9: Select one of the remote interfaces and click 'Start' button to start remote capturing on the interface. Click 'OK' to finish adding the remote interfaces. I have two interfaces on the remote host. Start and stop the capture services on windows systems manually. Wireshark will connect to the remote host and pull the remote interfaces information. If you don’t install WinPcap or npcap on this system, than this issue does not occur.īut of course, you can´t take a capture with such a wireshark anymore. But there are some workarounds which can help in this case: Solution 1:ĭon´t install the capture drivers at windows systems.

Wireshark capture interface